Blind Rivets - Standard Flange - 6.4 x 12mm
Please sign in so that we can notify you about a reply
Blind Rivets Standard Flange 6.4 x 12mm
POP AVDEL standard flange blind rivets are mainly used in applications where there is no access to the rear (blind side) of the joint.
Installing a blind rivet is a simple and fast process which is what gives POP rivets their excellent reputation.
- Drill a correctly sized hole into your materials where you want your rivets.
- Place the Rivet Installation Tool on the mandrel of the rivet.
- Activate the tool (usually by some lever or trigger mechanism) to pull the mandrel towards the surface.
When the mandrel gets tight in the material it will snap off at a predetermined point leaving the "hat" with a portion of the mandrel stuck inside. A properly sized and installed blind rivet will hold tightly and strong as a permanent joint in the materials. If the hole was too big the rivet will be loose and spin and if the drilled hole is too small the rivet will not install correctly leaving a bad seal.
Techincal Specifications:
- Material: Aluminium
